A standard angle board covers the corner and a strip of each face. A wide leg covers much more of the face, which changes what the protector does: it starts protecting the surface against abrasion and marking, not only the edge against crushing.
What a wide leg protects that a narrow one does not
A wide leg spreads band pressure across a larger area, which is the difference between a faint line and a visible mark on a finished face. It also takes the abrasion from film, from the next pallet and from handling.
On printed or coated goods the marking risk is the main risk, and that is where a wide leg earns its cost.
Specification at a glance
Legs run from 25 mm to about 100 mm; beyond that the part behaves as a panel and should be specified as one, with different freight and cost.
| Face | Leg | Why |
|---|
| Flat printed panel | Wide | Marking and abrasion |
| Coated sheet | Wide, clean face | Surface quality |
| Hardware on face | Narrow | Avoid bridging |
| Banded cartons | Medium | Spread band load |
| Very wide cover | Panel | Different product |
Where it goes wrong
A wide leg on an uneven face bridges and creases. It is the right answer on flat panels and the wrong answer on anything with hardware, a recess or a lid lip.
It also uses more board, so the saving has to come from somewhere: fewer damaged units, fewer returns, or less film and tape used to protect the same face.
Comparing cost honestly
Comparing a wide leg to a narrow one by unit price always makes the wide leg look expensive. The comparison that matters is cost per protected pallet, which includes the damage it prevents and the film it replaces.
For heavy repeat packs, the wide leg often reduces total packaging cost because it does the job of both an edge protector and a face interleaf.
One practical test before committing: fit a single wide-leg piece to the worst pallet in the line, wrap it and open it again. If the face comes out unmarked and the board still lies flat, the specification is right. If it has creased at a fitting, the leg is too long for that pack and no amount of extra wall thickness will fix it.
Questions buyers ask before ordering
What does a wide leg add?
Face coverage, so it protects against marking and abrasion as well as edge crush.
Is there a limit?
Around 100 mm; beyond that it is a panel and should be specified as one.
Where is it wrong?
On faces with hardware or recesses, because it bridges and creases.
Does it cost more?
Per unit yes, per protected pallet often no.
Does it replace film?
On some packs it reduces the film or interleaf needed, which is where the saving comes from.
Send the panel edge, the band positions and the pack weight to mona@hengnicepacking.com and we will quote the profile that fits.