Search

PVC Foam Board: A Soft Edge That Dents Instead of Chipping

PRODUCT DETAILS

PVC foam board is light, closed-cell and soft at the edge compared with a mineral panel. It dents rather than chips, which sounds forgiving until the dent is on a face that has to be printed or laminated, because a dented surface cannot be flattened out again.

What actually damages foam board

Pressure, more than impact. Bands and stacked weight leave permanent dents, and the board does not recover because the cell structure has collapsed locally.

The edge is also where the cut face is open, so it takes marks and dirt that show through on a white board.

Specification at a glance

Foam board is light for its thickness, so the leg covers the edge and the wall spreads the band. A heavy wall is not needed; a wide leg is.

BoardProfileNote
Thin foamNarrow channelTo thickness
Thick foamWide legSpreads band
White boardClean kraftMarks show
Film wrappedCorner boardFilm tension
StackedBottom stripWeight dents

Banding a soft stack

The risk on a foam stack is over-tensioning: the band does not need to bite, it needs to hold. A protector under the band spreads that tension over the leg so the board does not dent at the band line.

Where stacks are film-wrapped, the film itself can dent a soft edge if it is applied tight without a corner board.

The line to watch is where the band changes direction. A band that runs down one face and turns under the pallet pulls hardest at the turn, and on a soft board that turn is the first dent. A short piece of protector at the turn costs little and prevents the most visible damage on the pallet.

White board and print

White and printed foam board shows every mark, so a clean kraft face and clean gloves at the packing station are part of the specification, not a detail.

Where the board will be printed after delivery, the edge is often the reference surface, so a dented edge causes a registration problem as well as a cosmetic one.

Questions buyers ask before ordering

Does foam board need protection?
Yes. It dents under band and stack pressure, and a dent cannot be repaired.

Heavy wall or wide leg?
Wide leg. The board is light; the problem is pressure, not impact.

Can film dent it?
Tight film can, which is why a corner board under the film matters.

Why clean kraft for white board?
Because every mark and every bit of dust shows on a white face.

Is it used before printing?
Often, and a dented edge then becomes a registration problem as well.

Send the panel thickness, the edge condition and the pack weight to mona@hengnicepacking.com and we will quote the U profile that fits.

Inquire Now

If you have any questions or needs about the product, please fill in the following form and we will contact you as soon as possible.

+8615653268176