Search

Pipe Bundles: Protecting a Round Edge That Rolls

PRODUCT DETAILS

A pipe bundle has no edges in the panel sense, so protection goes where the bundle actually touches: the outer pipes at the band positions and the bundle ends. A U profile fitted over the outer pipe at each band spreads the band load and keeps the pipe coating away from the steel band.

Where a pipe bundle gets marked

Bands cut into the outer pipe wall or the coating, and the ends take the handling. On coated or lined pipe the band mark is a rejection, because the coating is the product.

Where bundles are stacked, the contact between bundles is line contact, which is high pressure on a small area.

Specification at a glance

Pipe diameter sets the inside width of the profile at the band position, and the length is short because each piece only covers the area around one band.

ContactProtectionNote
Band on outer pipeShort U at each bandCoating protection
Bundle to bundleContact padLine contact
Bundle endEnd protectionDifferent component
Threaded endThread protectorNot a U profile
Longitudinal bandRun under the bandDifferent geometry

Fitting to a round surface

A rigid profile on a round pipe touches on a line unless the profile is notched or the leg is short enough to sit flat. For most bundles a short leg at each band is more effective than a long run that only touches at one point.

Where the band runs along the bundle rather than around it, the contact geometry changes and the protector goes under the band along its length instead.

Ends, threads and coatings

Threaded ends need their own protection and it is a different component; a U profile on the bundle body does not protect a thread.

Coated pipe should be specified with a clean kraft face, because a marked board on a coated surface leaves a print that has to be removed before delivery.

Questions buyers ask before ordering

How does a U profile fit a round pipe?
Short legs at each band sit flat enough to work; a long rigid run touches only on a line.

Does it protect the coating?
Yes, that is the main job at the band, because a band mark on coated pipe is a rejection.

Are ends protected by the same profile?
No. Ends and threads need their own protection.

What length is used?
Short pieces at each band, rather than a run along the bundle.

Can it be used on stainless?
Yes, with a clean kraft face to avoid marking a bright surface.

Tell us the edge to protect, quantity per shipment and how it is banded at mona@hengnicepacking.com and we will advise on the board build.

Inquire Now

If you have any questions or needs about the product, please fill in the following form and we will contact you as soon as possible.

+8615653268176