Search

Picture Frames: Protecting Four Mitred Corners at Once

PRODUCT DETAILS

A frame is four mitred corners joined at their weakest point, with glass and a finished moulding behind them. The corner is where damage shows first and where repair is least possible, because a crushed mitre cannot be closed again without taking the frame apart.

Why the mitre is the vulnerable point

The joint is end grain to end grain, glued and pinned. It has little resistance to a knock from outside, and a knock that opens the joint by a fraction is visible on a hung frame.

Frames also stack on their corners, so the same four points take the load of everything above them.

Specification at a glance

Moulding depth sets the inside width; the leg covers the face and the back just enough to hold the corner without pressing on glass or a decorative finish.

MouldingProfileNote
Gilt or paintedClean or coated kraftCannot be touched up
Raw timberStandard kraftGeometric damage
Deep mouldingWider channelTo depth
Stack cornersCorner protectionHandling
Upright crateHeavier at bottomWeight

Gilt, painted and raw mouldings

Gilt and painted finishes mark from any contact with a rough board, and they cannot be touched up invisibly. A clean kraft face is the minimum, and a coated face is better where the finish is delicate.

Raw timber mouldings are more forgiving of contact but still show a crushed corner, because the damage is geometric rather than cosmetic.

Packing frames in a stack

Frames are usually packed face to face with interleaving, and the four corners of the stack take the handling. Protecting the stack corners covers most of the risk; protecting every frame corner covers all of it at a higher cost.

Where frames are shipped upright in a crate, the bottom corners carry weight and need the heavier option, while the top corners need impact protection.

One detail that is easy to miss: a frame corner protector should grip the moulding, not the glass. If the channel is deep enough to reach the glass, the first knock transfers straight through the paper into the edge of the pane.

Questions buyers ask before ordering

Why is the mitre the weak point?
It is end grain to end grain, glued and pinned, with little resistance to a knock from outside.

What face for gilt frames?
Clean or coated kraft, because a gilt finish cannot be touched up invisibly.

Protect every frame or the stack?
Stack corners cover most risk; every corner costs more and protects more.

Does moulding depth matter?
Yes, it sets the inside width of the channel.

What about upright crates?
The bottom corners carry weight and need the heavier option.

Share the drawing or the pack photo with mona@hengnicepacking.com and we will confirm feasibility before quoting.

Inquire Now

If you have any questions or needs about the product, please fill in the following form and we will contact you as soon as possible.

+8615653268176