Search

Caravan Panels: A Sandwich That Fails at the Edge First

PRODUCT DETAILS

Caravan and motorhome bodies are built from sandwich panels: thin skins over a foam or timber core. The skins are bonded to the core, and the bond is weakest at the cut edge, which is why an edge that has been knocked shows as a delamination rather than a dent.

Why the edge is the weak point

The skins carry the load, and at the edge there is only the bond between skin and core. A strike at that line starts a separation that grows once the panel is flexed.

A separating edge is hard to repair invisibly, which is why panel suppliers treat edge damage as a rejection rather than a touch-up.

Specification at a glance

Panel thickness sets the inside width, and the leg has to cover the edge plus enough of both faces to hold the skins.

PanelProfileNote
Sandwich, thin skinChannel to thicknessBond at edge
Bottom edge, verticalWider legFull panel weight
Aperture edgesShort piecesLifting points
Trimmed edgeClearance legDo not press trim
Transfer packCorner protectionHandled often

Stacking during transport to the line

Panels usually travel from the panel maker to the body builder, so the pack is a transfer pack rather than an export pack. It is handled more often and for shorter distances, which puts the emphasis on edge protection rather than band pressure.

Vertical storage on site is common, so the bottom edge takes the whole panel weight and needs more than a corner piece.

Cut-outs, apertures and finished edges

Panels with door or window apertures have more edges than the outline, and those apertures are where handling damage happens because they are lifted by them.

Where an edge is already sealed or trimmed, the protector must not press on the trim, so a wider channel with a clearance leg is the practical answer.

Questions buyers ask before ordering

Why do caravan panels fail at the edge?
The skin-to-core bond is weakest there, so a strike starts a delamination rather than a dent.

Does the bottom edge need more?
Yes, when panels are stored vertically the bottom edge carries the panel weight.

What about apertures?
They are lifting points, so they take handling damage and need short pieces.

Will it press on a trim?
Not if a clearance leg is specified; a standard channel can press on the trim.

Is this an export pack?
Usually a transfer pack between panel maker and body builder, handled more often than a sea pack.

Share the drawing or the pack photo with mona@hengnicepacking.com and we will confirm feasibility before quoting.

Inquire Now

If you have any questions or needs about the product, please fill in the following form and we will contact you as soon as possible.

+8615653268176