A symmetrical U profile assumes both faces of a panel need the same protection. Often they do not: one face is finished and visible, the other is hidden against the next panel, or one side carries hardware that a long leg would bridge. Unequal legs let the profile follow the pack instead of forcing the pack to suit the profile.
What unequal legs solve
Cover on the visible face, clearance on the hidden one. That is the common case: a finished door face and a raw back, or a panel with a rail that a full leg would cross and crease on.
It also saves board. A leg that is doing nothing is still board, still weight and still freight volume.
Specification at a glance
Both legs are specified separately, and the inside width stays the panel thickness. The rule is that the longer leg goes on the face that can be marked.
| Case | Long leg | Why |
|---|
| Finished face | On the visible side | Marking risk |
| Rail or hardware | On the clear side | Avoid bridging |
| Door leaf | On the face | Finish quality |
| Stacked panels | On the outer face | Handling contact |
| Cost driven | Shorter both sides | No wasted board |
Where the fold sits
The fold line is the datum. If the panel is not centred in the channel, the fold moves toward the shorter leg, and the profile has to be drawn from the fold rather than from the middle.
That is the one thing that goes wrong on a first order: the drawing shows two legs, the fitter centres the panel, and the long leg ends up short.
Print, orientation and packing
Where print is applied, unequal legs create a right way round. Mark the bundle or print an orientation mark, or half the pallet will be fitted backwards.
Packing follows the longer leg, because that is what sets the bundle height.
Questions buyers ask before ordering
Why use unequal legs?
When one face needs cover and the other needs clearance, or when a symmetrical leg would bridge a fitting.
Does it cost more?
Usually less, because a leg that does no work is board you paid for and freight you paid for.
How is it specified?
Two leg dimensions plus the inside width, drawn from the fold line.
Can it be printed?
Yes, and then an orientation mark matters so it is fitted the right way round.
Is the fold centred?
Only if the panel is. Otherwise the fold sits toward the shorter leg.
Share the drawing or the pack photo with mona@hengnicepacking.com and we will confirm feasibility before quoting.