A window sill is wider than it is thick, with a square or slightly chamfered edge and a face that is often pre-finished. That combination means the edge is vulnerable to chipping and the face is vulnerable to marking, and both are visible once the sill is installed under a window.
Why a sill needs a different profile
The thickness is small and the width is large, so a channel sized to the thickness has little grip on the face. That is why sills are usually protected with a channel that also has a wide leg, rather than a standard square U.
The edge itself is a sharp arris, and a sharp arris chips more readily than a rounded one. Protecting it is about keeping that line intact through handling.
Specification at a glance
Inside width follows the sill thickness, and the leg covers enough of the face to hold the piece without pressing where the sill will be visible after installation.
| Sill | Profile | Note |
|---|
| Composite | Wide leg | Marks easily |
| Timber | Wide leg, clean kraft | No sanding on site |
| Stone | Wider leg | Bottom carries weight |
| Stack | Top and bottom | Handling |
| Long site storage | Simple channel | Moved often |
Composite, timber and stone sills
Composite and timber sills mark easily and cannot be sanded back on site, so the board that touches them has to be clean and the band has to be spread.
Stone sills are heavier and behave like a slab: the bottom edge carries weight and needs a wider leg rather than a thicker wall.
Stacking and the installation interface
Sills are usually stacked flat, so the top and bottom pieces take the handling and the middle ones mostly need separation. Protecting the top and bottom of the stack is the efficient specification.
Because sills are installed early in a build, they often sit on site for a while, so the protection has to survive being moved between rooms.
Questions buyers ask before ordering
Why not a standard square U?
Sills are wide and thin, so a wide leg holds the piece and a square profile has little grip.
Which edge is at risk?
The sharp arris, which chips more readily than a rounded edge.
Does a stone sill need more?
A wider leg at the bottom edge, because the stack weight lands there.
Will it mark a composite sill?
A clean dry board will not; a marked board will, and it cannot be sanded back.
Which pieces of the stack need protection?
Top and bottom do most of the work; the middle needs separation.
For a quotation, post the panel size, the band positions and the destination port to mona@hengnicepacking.com.