Search

Rubber Sheets: Heavy, Flexible and Easy to Mark

PRODUCT DETAILS

A stack of rubber sheet is heavy, dense and slightly compressible, and it grips whatever it touches. That grip is the problem: a band on a rubber edge does not slide, so the mark it leaves is a permanent indentation rather than a surface scuff.

Why rubber marks differently

The material deforms under load and does not spring back fully, especially at the edges where there is less material to distribute the stress. A band line on a rubber stack is a groove.

Rubber also takes up marks from whatever it is stacked against, including board edges, so the protector has to be smooth and clean rather than merely present.

Specification at a glance

Sheet thickness sets the inside width; a wider leg spreads the band over more area, which is the single most effective change on a rubber stack.

FormProtectionNote
Sheet stackWide leg channelSpreads band
Bottom of stackCorner to deckLoad
Roll endRing, not channelCircular edge
Bare cornerAlways coveredGrooving
Soft compoundClean smooth kraftTakes marks

Weight, stack height and the deck

Rubber is heavy for its thickness, so the bottom of the stack carries a lot of load. Corner protectors that extend to the deck spread that load rather than letting the bottom sheet take it on its edge.

Bands should be positioned over protectors on all four corners, because a band that crosses a bare rubber corner will groove it regardless of how good the other three are.

Rolls, sheets and cut pieces

Sheet stacks and roll ends behave differently: rolls need protection on the circular edge, which is a ring rather than a channel, while cut sheets need the channel.

Where both are in one shipment, specify them separately rather than trying to make one profile do both jobs.

Check the cut edges of the stack before wrapping. Rubber that has been guillotined or water-jet cut can have a slightly ragged edge, and a band over a ragged edge grooves deeper than over a clean one.

Questions buyers ask before ordering

Why does a band groove rubber?
Rubber deforms under load and does not spring back fully, so the mark is an indentation.

What helps most?
A wider leg, because it spreads the band over more area.

Do all four corners need it?
Yes. One bare corner is enough to groove the stack.

What about roll ends?
Those need a ring, not a channel.

Does weight matter?
Yes, a rubber stack is heavy, so protectors should extend to the deck.

Tell us the edge to protect, quantity per shipment and how it is banded at mona@hengnicepacking.com and we will advise on the board build.

Inquire Now

If you have any questions or needs about the product, please fill in the following form and we will contact you as soon as possible.

+8615653268176