Search

Polycarbonate Sheets: Protecting an Edge Nobody Can Repair

PRODUCT DETAILS

Polycarbonate sheet is supplied with a protective film on both faces and nothing on the edge. That edge is where a sheet fails first: a chip in polycarbonate cannot be polished out the way a scratch on the face can, and the film does not protect it. A U channel covers the edge and both faces at the same time, which is what a sheet pack needs.

Why the edge matters more than the face

The face already has film. The edge has nothing, and it is the part that lands on a pallet deck, a stillage rail or the sheet behind it.

A chipped edge on a glazed or multiwall sheet also breaks the cell structure at that point, which is visible once the sheet is installed.

Specification at a glance

Sheet thickness sets the inside width, and the length follows the strap positions rather than the sheet length.

SheetInside widthNote
Multiwall, thinNarrow channelHollow edge crushes
Multiwall, thickWide channelWider leg helps
Solid sheetTo thicknessHeavier wall suits
Coated sheetTo thicknessClean kraft face
Stack on deckBottom stripDeck contact

Film, tape and the fitting order

Fit the channel over the film, not under it. Removing film to fit protection defeats the purpose, and re-applying tape to hold it leaves adhesive on the face that has to be cleaned later.

Where sheets are stacked, the channel holds the stack edge square while the film is not yet tight, which is exactly when a corner takes a knock.

Multiwell, solid and coated sheet

Multiwall sheet has a hollow edge that crushes easily, so a wider leg is worth more than a thicker wall there. Solid sheet behaves more like a panel and takes a heavier wall.

Coated and anti-static grades are the ones where a marking board shows, so specify a clean kraft face for those.

Questions buyers ask before ordering

Does polycarbonate need edge protection?
At the edge, yes. The face has film; the edge has nothing and cannot be repaired if it chips.

Should the channel go over the film?
Over it. Removing film to fit protection defeats the purpose.

What about multiwall sheet?
A wider leg suits the hollow edge, because the edge crushes before the face marks.

Can it be cut to the sheet length?
Yes, to 6,000 mm, and to the strap positions if the stack is banded.

Will it mark a coated sheet?
A clean kraft face will not; a marked or damp board can.

Send the panel thickness, the edge condition and the pack weight to mona@hengnicepacking.com and we will quote the U profile that fits.

Inquire Now

If you have any questions or needs about the product, please fill in the following form and we will contact you as soon as possible.

+8615653268176