Search

Acoustic Panels: Protecting a Soft Face and a Fragile Corner

PRODUCT DETAILS

An acoustic panel is usually a soft core with a fabric, felt or veneer face. The face is what the buyer inspects, and the corner is where the face lifts. Protection therefore has to cover the corner without pressing hard enough to leave a mark in the facing.

What goes wrong with acoustic panels

Two failures, in this order: the corner crushes and the facing lifts at the crushed point, then the panel will not sit flat against a wall.

A tight band on a soft facing leaves a compression line that is visible under raking light, which is exactly how acoustic panels are viewed on site.

Specification at a glance

Panel thickness sets the inside width; a wide leg spreads the band so the facing is not locally compressed.

FaceProfileNote
FabricWide leg, clean kraftCannot be cleaned
FeltWide legCompression shows
VeneerHold the cornerLift risk
StackOuter cornersHandling contact
WrappedFit before wrapFilm pulls

Fabric, felt and veneer faces

Fabric and felt mark easily and cannot be cleaned, so the board that touches them has to be clean and dry. A marked board leaves a shadow that no vacuuming removes.

Veneer faces behave differently: they are harder but can lift at a corner, so the profile should hold the corner rather than press along the face.

A third case is the panel with an integrated frame or a fabric-wrapped return. There the corner is already thicker, so the profile has to sit outside the return instead of over it, which is usually a wider channel rather than a stronger one.

Stacking and the finished face

Panels are usually stacked face to face with a separator, and the outer corner takes the handling. Protection on the four outer corners of the stack covers most of the risk.

Where panels are wrapped, fit the corners first. A wrap applied over a bare corner pulls the facing at the corner as it tightens.

Questions buyers ask before ordering

Will paper mark a fabric face?
A clean dry board will not. A marked or damp one leaves a shadow that cannot be cleaned off.

Why a wide leg here?
To spread band pressure so the facing is not compressed along a line.

Should protection go on before wrapping?
Yes, otherwise the film pulls the facing at the corner.

How many corners?
The four outer corners of the stack cover most handling risk.

Does panel thickness matter?
It sets the inside width, so the profile sits without pressing the face.

For a quotation, post the panel size, the band positions and the destination port to mona@hengnicepacking.com.

Inquire Now

If you have any questions or needs about the product, please fill in the following form and we will contact you as soon as possible.

+8615653268176