Search

Cut to Length: Why the Cut Is Part of the Specification

PRODUCT DETAILS

A U channel is made in a continuous run and cut to the length the pack needs, from 300 mm up to 6,000 mm. The cut is not a detail: it sets the tolerance the fitting line has to work with, it decides how the pieces are bundled, and it is the part of the price that changes most when the length changes.

What the cutting step controls

Squareness at the ends, burr on the cut face and length tolerance. A square cut sits flat on the deck; a cut at an angle rocks and lifts under the band.

Tolerance is agreed rather than assumed, because a hand-fitted board and a machine-fed board need different numbers.

Specification at a glance

Length range and tolerance are the two figures to send. Anything shorter than 300 mm is a different component, not a shorter channel.

UseLengthNote
Band positionShort piecesMore cuts per metre
Panel edgeFull runFewer cuts
CornerShort, pairedFit by position
Maximum6000 mmLonger is segmented
Minimum300 mmBelow that, different part

Short cuts and long runs

Short pieces are used at band positions and corners; long runs cover a panel edge in one piece. Both are cut from the same board, but the cutting cost per metre differs sharply, because a metre made of short pieces needs more cuts.

For freight, long pieces are usually cheaper per metre but cost more in packing volume and can be damaged in transit themselves if the bundle is not supported.

Bundling, marking and the line

Pieces can be bundled by length or by pack position. Position-marked bundles cost a little more and save measuring at the line, which is usually the better trade on a repeat pack.

Where several lengths go into one pack, mark the bundle ends rather than relying on the outer wrap alone, because the wrap is the first thing that gets cut open.

Questions buyers ask before ordering

What is the length range?
300 mm to 6,000 mm. Longer runs are made from segments.

Why does length change the price?
Cutting is costed per piece as well as per metre, so short pieces cost more per metre.

What tolerance is normal?
It is agreed per order, because hand fitting and machine feeding need different numbers.

Can bundles be marked by position?
Yes, and it usually saves more at the line than it costs.

Do long pieces travel well?
Only if the bundle is supported; otherwise the protector itself arrives bent.

Tell us the edge to protect, quantity per shipment and how it is banded at mona@hengnicepacking.com and we will advise on the board build.

Inquire Now

If you have any questions or needs about the product, please fill in the following form and we will contact you as soon as possible.

+8615653268176