Search

Stone Slabs: Protecting an Edge That Chips Before It Bends

PRODUCT DETAILS

Stone does not bend, it chips. That single fact changes what edge protection is for: on a slab bundle the profile is not spreading a flexible load, it is keeping a hard edge away from every other hard surface — the A-frame, the band, the slab behind it and the deck.

Where a slab edge gets damaged

Three contacts: slab against slab in the bundle, band against the top corner, and bundle against the A-frame or the deck. Each is a hard-on-hard contact with no give on the stone side.

A chip on a polished edge is not repairable without re-polishing the whole edge, which is why the cost of prevention is so much lower than the cost of a claim.

Specification at a glance

Slab thickness drives the leg, bundle height drives the length, and the wall is chosen for the weight of the slab rather than for the band alone.

ContactProtectorNote
Band on top cornerL profile, heavier wallBand interface
Slab against slabEdge stripHigh local pressure
A-frame contactWide legFull bundle weight
Deck contactBottom stripVertical bundles
Sling pointSeparate padDifferent component

Slab against slab

In a bundle, slabs touch along their faces and their edges. The edge contact is small but the pressure is high, so a strip or a profile between slabs at the edge is often worth more than thicker protection at the outside.

Where slabs are separated by foam or felt, the protector at the outer corner still does the band interface job.

A-frames, decks and the vertical bundle

Vertical bundles on an A-frame put the full weight through the bottom edge. That is where a wider leg and a heavier wall earn their cost.

Where the bundle is lifted with slings, the sling contact point should be protected as well, and it is usually a different component from the corner profile.

Questions buyers ask before ordering

Does paper protect stone?
It keeps hard surfaces apart and spreads the band load. It does not stop a slab from chipping if the bundle is dropped.

What matters most, wall or leg?
For vertical bundles, leg width at the bottom edge; for band interface, wall thickness.

Should slabs be separated in the bundle?
Where edge contact is the risk, yes, with a strip or felt between slabs.

Is it used on A-frames?
Yes, at the bottom edge and at the frame contact points.

Can it be used with slings?
The sling point needs its own protection; a corner profile is not a sling pad.

Tell us the edge to protect, quantity per shipment and how it is banded at mona@hengnicepacking.com and we will advise on the board build.

Inquire Now

If you have any questions or needs about the product, please fill in the following form and we will contact you as soon as possible.

+8615653268176