A slot in a paper edge protector is a controlled weakness. Cut in the right place it lets a rigid profile turn a corner, follow a curve or fold flat for freight; cut in the wrong place it becomes the point where the board tears under load. The difference is the direction of the slot and the distance from the fold line.
Two kinds of slot, two jobs
A notch across the leg lets the profile bend in the plane of the leg, which is how a U or L profile wraps a corner. A slot parallel to the fold line weakens the profile along its length, which is what you want when it has to follow a radius, and what you never want at a strap line.
Buyers often ask for slots without stating which behaviour they need. The answer changes the cut, the board grade and sometimes the profile itself.
Specification at a glance
The table maps the intent to the cut, using the dimensions a drawing needs.
| Intent | Cut | Drawing needs |
|---|
| Bend round a corner | Notch across the leg | Angle, leg, notch pitch |
| Follow a radius | Slots parallel to fold | Radius, slot length, pitch |
| Fold flat for freight | Single score | Fold position |
| Clear a fitting | Local cut-out | Position and size |
| High load, no bend | No slot | Keep it solid |
Slot spacing and the strap line
Where a profile is notched to bend, the spacing between notches sets how tightly it turns and how much edge is left uncut. Notches too close together leave thin fingers that fold over; too far apart and the bend fights back and creases.
The strap line should never land on a slot. Move the slot, move the strap, or add a second uncut band where the banding crosses, because a slot under tension is where a tear starts.
Cut faces and handling
Every slot exposes the plies. A clean cut leaves them bonded; a torn cut leaves them loose, and loose plies lift in handling and then catch on the product.
Where the profile will be handled many times, ask for the slots to be cut rather than crushed, and check the first bundle at the cut face rather than at the outside of the pack.
Questions buyers ask before ordering
Does a slot make the protector weaker?
Yes, locally. That is the trade for bendability, and the slot has to be kept away from the strap line.
Can a standard L profile be slotted after cutting?
Not reliably. The slot is part of how the piece is made, so it belongs on the drawing.
How tight can a notched profile turn?
It depends on the notch pitch and the board thickness; a sample is the fastest way to settle it.
Will the cut edges fray?
A clean cut holds the plies. A crushed cut does not, which is why the cut face is worth checking.
Can slots be combined with printing?
Yes, but print should avoid the slot area or it will break across the cuts.
Send the panel edge, the band positions and the pack weight to mona@hengnicepacking.com and we will quote the profile that fits.