Search

MOQ on Paper Edge Protectors: Why It Depends on the Size

PRODUCT DETAILS

There is no single minimum order for a paper edge protector, because the constraint is not the product, it is the run. A size that is already being made has a different minimum from a size that has to be set up, and a printed profile has a different minimum again from a plain one. Asking for the minimum before stating the size gets an answer that will not hold.

What sets the minimum

Three things: the cutting setup for a non-standard length or leg, the print setup where a plate is needed, and the packing unit the line runs in.

A plain profile in a size close to a running job can go out in a small trial quantity. A new leg and wall combination has to be set up, and that setup is what the minimum pays for.

Specification at a glance

The table shows how the minimum moves with the type of request. Exact figures are confirmed against the size, because publishing one number would be misleading.

RequestWhat drives the minimumNote
Standard leg and wallCutting runLowest minimum
New leg or wallSetupHigher
Custom lengthCutting setupHigher for short cuts
Printed profilePlate and print runHighest
Mixed sizes, one packQuoted as one orderEach size lower
SampleNot an orderNo minimum

Trials, samples and the first order

A sample is not an order and does not carry the minimum, which is why a trial is the normal first step on a new pack. The sample confirms fit and grade; the first production order confirms the line.

Where a buyer needs several sizes for one pack, the sizes are quoted as one order rather than several, which usually brings each size below its standalone minimum.

Why we do not publish one figure

Because it would be wrong for most enquiries. A quoted minimum that does not apply wastes a week of the time of the buyer and makes the real quote look like a change of terms. The honest sequence is size, then grade, then quantity, then the minimum for that combination.

Questions buyers ask before ordering

What is your MOQ?
It depends on the size, the grade and whether print is involved. Give those three and the figure is exact.

Can I order a small trial?
A sample yes. A production trial depends on whether the size is already running.

Does print raise the minimum?
Yes, because a plate and a print run are involved.

Can several sizes be combined?
Yes, and that usually brings each size below its standalone minimum.

Why not publish a number?
A single figure would be wrong for most enquiries and would mislead buyers.

Send the panel edge, the band positions and the pack weight to mona@hengnicepacking.com and we will quote the profile that fits.

Inquire Now

If you have any questions or needs about the product, please fill in the following form and we will contact you as soon as possible.

+8615653268176