A mirror is a glass sheet with a reflective coating on the back, and both faces matter: the front shows every mark and the back shows every scratch through the silvering. Edge protection for mirrors therefore has to do two jobs at once, hold the corner and keep anything abrasive away from the faces.
Two failures, one edge
The first is chipping, which starts at the edge and can run into the sheet. The second is abrasion on the back coating, which does not break the glass but ruins the reflection at that point.
Both start at the corner, because that is what touches the pallet deck, the A frame and the next mirror in the stack.
Specification at a glance
Thickness of the glass sets the channel; the leg covers the edge and enough of both faces to hold the pack without pressing on the silvering.
| Position | Protection | Note |
|---|
| Corner | Channel over edge | Chip risk |
| Bottom edge | Wider leg | Carries weight |
| Face contact | Pad, not board | Silvering |
| A frame rail | Strip | Contact line |
| Stack | Clean dry kraft | Grit scratches |
A frames, stillages and stack angles
Mirrors travel in A frames or stillages at a shallow angle, so the bottom edge carries weight and the top edge takes handling. Protect both ends, and protect the contact line where the mirror meets the frame.
Where mirrors are stacked face to face, the protector should not press on the reflective face. Contact pads at the corners are the usual compromise.
Cleanliness is part of the specification
Paper against a mirror face must be clean and dry. Grit in a board leaves a scratch that shows in reflected light and cannot be polished out without damaging the coating.
Packing under a dust cover and keeping the boards wrapped until the last moment is what separates a mirror pack that arrives perfect from one that arrives nearly perfect.
Questions buyers ask before ordering
Why protect a mirror edge specifically?
Because a chip starts at the edge and runs, and the silvering is close to that edge.
Will paper scratch the face?
Clean dry paper will not; grit in the board will, and it cannot be polished out.
What about the back?
It is coated, so abrasion there ruins the reflection without breaking the glass.
How are mirrors usually shipped?
In A frames or stillages at a shallow angle, so both ends need protection.
Should boards be wrapped?
Yes, until the last moment, because dust and grit are the enemy.
Tell us the edge to protect, quantity per shipment and how it is banded at mona@hengnicepacking.com and we will advise on the board build.