Search

Lateral Compression: Load Along the Wall, Not Across It

PRODUCT DETAILS

Lateral compression is the load that runs along the wall of the profile, as it does when protectors stand vertically at the corners of a stacked pallet and carry the weight of the tiers above. It is the load case that decides whether a corner protector can act as a column.

Why a corner becomes a column

When protectors are fitted vertically, the bottom piece carries the stack. That is a column load, and a folded paper section behaves like a short column: it holds well until it buckles, then gives up quickly.

Buckling is the reason a visually undamaged protector can still have failed. The wall folds outward and the stack settles by a few millimetres, which is enough to slacken the film.

Specification at a glance

Wall thickness and leg length both contribute: a wider leg is a more stable column than a thick wall on a narrow leg.

ConditionEffectFix
Full height fitActs as columnCorrect
Stops shortNo columnCut to height
Wide legMore stablePrefer over wall
Damp boardBuckling earlyDry storage
All four failedWall too lightHeavier wall

Support conditions matter as much as the board

A column that is held square at both ends carries more than one that can lean. In a pack, that means the protector should reach the deck and the top board rather than stopping short at either end.

Where protectors stop below the top of the stack, the load above them is carried by the cartons, and the protectors are doing nothing structurally.

Reading a failed stack

A stack that leans to one corner usually has one protector that buckled early, often the one that was short or damp. Checking the cut ends tells you which one was cut short at packing.

If all four failed, the wall is under-specified for the stack height, and the fix is a heavier wall or fewer tiers per pallet.

One measurement worth taking: the gap between the top board and the top of the protectors on a sample pallet. If there is a gap at all, the protectors have stopped short and the stack above them is riding on cartons rather than on paper.

Questions buyers ask before ordering

What is lateral compression here?
Load running along the wall, as when protectors stand vertically and carry the stack.

Why does it fail suddenly?
A folded section behaves like a short column: it holds until it buckles, then gives up.

Wide leg or thick wall?
A wide leg is the more stable column.

Does fit height matter?
Yes. A protector that stops short carries nothing.

Can a damp protector fail?
Yes, it buckles earlier than a dry one at the same load.

Share the drawing or the pack photo with mona@hengnicepacking.com and we will confirm feasibility before quoting.

Inquire Now

If you have any questions or needs about the product, please fill in the following form and we will contact you as soon as possible.

+8615653268176