A plywood sheet has a built edge rather than a cut one, and that edge is the easiest place to read damage: a crushed corner shows every veneer layer at once, and a buyer sees it before they see the face. Protective profiles on a sheet stack are therefore about holding the edge square, not only about the strap.
What fails on a plywood stack
The band compresses the top and bottom sheet edges first, because those are the ones with nothing behind them. Once the band has bitten, the stack can shift and the band goes slack.
Corners take the handling. A stack that is set down hard on a corner delaminates locally, and that is visible on all four faces of the corner.
Specification at a glance
Thickness of the sheet drives the leg, and the stack weight drives the wall. Length follows the strap positions rather than the stack length.
| Stack | Protector | Note |
|---|
| Sheets to 18 mm | Standard leg | Two positions per band |
| Sheets 18-25 mm | Wider leg | Covers the edge |
| Heavy stack | Thicker wall | Band pressure |
| Timber deck | Bottom strip | Deck contact line |
| Graded face | Clean kraft | No shadow transfer |
Banding, wrapping and the deck
Bands run over the stack, so the protector goes under the band on both faces, top and bottom, along the full band path. That is usually two positions per band.
Where the stack sits on a timber deck, the deck edge is a second contact line and takes a strip along the bottom edge as well.
Wrapping first and pushing protectors in afterwards defeats both: the wrap cannot hold a protector that was not under it.
Edge quality and the claim conversation
Plywood complaints are usually about the edge rather than the face. Photographing the pack before shipment, with the protectors visible at each band, settles most arguments about where the damage happened.
Where sheets are graded for face quality, a clean kraft board is the right interface; a marked or recycled-looking board can transfer a shadow onto a pale face under load.
Questions buyers ask before ordering
Does plywood need edge protection?
For the band and the corners, yes. Untreated banding crushes the top and bottom sheet edges first.
How many positions per band?
Two, one on each face, along the full band path.
Does sheet thickness change the leg?
Yes. Thicker sheets need a wider leg to cover the edge properly.
Can protectors be fitted under the wrap?
They should be, so the wrap holds them in place.
Will kraft mark a pale face?
A clean board does not; a marked or damp one can leave a shadow.
Share the drawing or the pack photo with mona@hengnicepacking.com and we will confirm feasibility before quoting.