Search

Oversized Cargo: Protecting Edges Where Nothing Is Standard

PRODUCT DETAILS

Oversized cargo breaks the assumption behind most edge protection: that the pack has corners in predictable places. A machine frame, a fabricated steel section or a skid-mounted unit has edges where the lashing falls rather than where the drawing says, and the protection has to be arranged around the lashing plan rather than around the product outline.

Start from the lashing plan, not the drawing

On out-of-gauge loads the lashing is what damages the cargo, because a chain or a web sling under tension is a line load on an unprotected edge. The protection goes where the lashing crosses, which the shipping plan already defines.

That usually means more positions than a standard pallet and fewer long continuous runs, so cut lengths are shorter and more varied.

Specification at a glance

The limits are honest and worth stating before a quote: our L profiles run to 6,000 mm in length, 25-100 mm leg and 2.5-8 mm wall. Beyond that, the answer is a different component, not a longer board.

ContactProtectionNote
Lashing crossing an edgeL profile at each pointLine load
Deck contactStrip under the skidSteel on steel
Frame contactCorner profileHard contact
Sharp fabricated edgeThicker wallBarrier to the sling
Long run over 6 mSegmented boardsLength limit

Flat rack, open top and the frame

On a flat rack the cargo contacts the deck and the frame, and both are hard steel. A board at each contact point is worth more than a continuous run that misses the actual touch points.

Where a fabricated frame has sharp edges, the protector is also a barrier between the edge and the sling, and a thicker wall is the right response rather than a wider leg.

Survey, fit and photograph

For oversized loads a fit survey is normal: measure the edges at the lashing positions, note the sharp ones, and photograph the result after fitting. That record is what settles a damage discussion later.

Where the load is assembled on site, the protectors are usually supplied cut to length and marked by position, so the crew does not have to measure anything at the port.

Questions buyers ask before ordering

What is the maximum length?
6,000 mm for an L profile. Longer runs are made from segments rather than one board.

How do I decide positions?
From the lashing plan, at every point where a sling or chain crosses an edge.

Is a wider leg better for sharp edges?
No. A thicker wall is the right answer for a sharp edge; width spreads load, thickness resists cutting.

Can protectors be marked by position?
Yes, and it saves measuring at the port.

Do you supply for flat rack loads?
Yes, cut to the lashing positions, with a fit survey if the load is complex.

Tell us the edge to protect, quantity per shipment and how it is banded at mona@hengnicepacking.com and we will advise on the board build.

Inquire Now

If you have any questions or needs about the product, please fill in the following form and we will contact you as soon as possible.

+8615653268176