A tile pallet is heavy, dense and edge-fragile at the same time. The glazed edge of the outer tile is what a buyer inspects first, and it is also what the band and the pallet corner press against. Paper profiles work here because the load path is short and the contact is what matters most.
What a tile pallet asks of a protector
The pallet is usually corner-protected on all four vertical corners, with a top frame or a cap, and banded vertically. The band crosses the top edges, so that is the first place to protect.
Tiles are heavy for their volume, so the profile takes real pressure at the corners without much give in the pack.
Specification at a glance
Tile pallets are standardised in most factories, which makes the protector easy to specify once: leg to cover the pallet corner, wall for the stack weight, length to the pallet height.
| Position | Protector | Note |
|---|
| Vertical corner | L profile | Under the band |
| Top edge | Cap or strip | Band crosses here |
| Horizontal band | Face strip | At band height |
| Polished edge | White facing | No transfer |
| Pallet base | Bottom strip | Deck contact |
Glazed edges and surface transfer
A glazed edge shows any transfer, so the board has to be clean and dry. Where the outer tile is polished or large-format, a white facing is worth considering for the same reason it is used on furniture.
Dust is the practical problem on a tile line. A protector stored open collects grit, and grit under band pressure marks the edge it was bought to protect.
Banding, corner boards and the cap
Vertical bands cross the top corner, so the corner profile has to sit under the band, not beside it. Where a top cap is used, the cap takes the band and the corner profile takes the vertical contact.
Horizontal banding around the pallet needs a strip at the band height on each face, which is a different component from the vertical corner.
Questions buyers ask before ordering
Do tile pallets need edge protection?
At the band path and the vertical corners, yes. The band crushes the top edge first.
Will paper mark a glazed edge?
A clean dry board does not. Grit under pressure does.
Should the protector go under the band?
Yes, so the band presses on paper rather than on tile.
Is a cap needed as well?
Where the band crosses the top edge, a cap or strip at that line is worth having.
Can the same profile be reused across pallet sizes?
Often yes, if the pallet heights are similar.
Send the panel edge, the band positions and the pack weight to mona@hengnicepacking.com and we will quote the profile that fits.