Search

Bending Strength: Why an Angle Board Fails in the Middle

PRODUCT DETAILS

Bending strength is what an angle board has when it spans a gap with load on it: between two pallet decks, across a crate opening, over an unsupported section of a stack. It is a different property from crush resistance, and a profile that is excellent in compression can be disappointing in bending.

What bending strength depends on

Three things: the wall build, the depth of the section along the direction of load and the unsupported span. The span dominates, because stiffness falls sharply as the distance between supports increases.

A profile is a folded section, so its bending behaviour differs depending on whether the load pushes against the fold or tries to open it. Load against the fold is the strong direction.

Specification at a glance

Wall thickness is the lever you can pull; the span is usually fixed by the pack. Where the span cannot change, wall is the only answer that does not add a new component.

CaseWeak directionFix
Across a gapSpan too longHeavier wall
Load opens foldFold directionRotate the piece
Against foldStrongWall as needed
Long unsupported runSag and creepShorter span

Where spans appear in a real pack

A strip spanning the gap between two pallet boards, a protector bridging a hand hole, a crate where the protector crosses an opening. In each case the piece is a beam, not a corner guard.

The usual failure is not a snap: the board sags first, the band loses tension and the stack settles. That looks like a strap problem and is really a bending problem.

Testing it without a laboratory

Support the piece across the span it will see in the pack and load it with the weight it will carry, then measure the sag after a few hours rather than a few seconds. Paper creeps, so time is part of the test.

If it has sagged visibly, the answer is a heavier wall or a shorter span, not a tighter band.

Questions buyers ask before ordering

Is bending strength the same as compression?
No. Bending is load across a span; compression is load along the wall.

What increases bending strength?
Wall build, and a shorter span. Span matters most.

Which way round should it sit?
Load against the fold; load that opens the fold is the weak direction.

How do I test it?
Support at the real span, load with the real weight, and measure sag over hours, not seconds.

Can a tighter band fix sag?
No, it hides it temporarily and the stack still settles.

For a quotation, post the product size, the band positions and the destination port to mona@hengnicepacking.com.

Inquire Now

If you have any questions or needs about the product, please fill in the following form and we will contact you as soon as possible.

+8615653268176