Search

Aluminium Extrusions: Long Profiles That Bend Before They Break

PRODUCT DETAILS

An aluminium extrusion bundle is long, relatively light and easy to bend. It does not usually arrive broken; it arrives bowed, with handling marks along one face and the anodised finish rubbed where the band crossed it. Protection therefore targets straightness and surface, not breakage.

What actually goes wrong with extrusions

Bowing comes from support spacing rather than impact: a bundle supported only at its ends sags under its own weight over a long span. The protector cannot fix that, but the bundle packing can.

Surface damage comes from bands and from bundle-to-bundle contact, and on anodised or powder-coated profiles a mark is a rejection because the finish is the product.

Specification at a glance

The channel sits at the band positions, and the leg covers the face that will be visible. Length is short at each band rather than a full run, unless the bundle is also being used to hold the pack square.

ContactProtectionNote
Band on anodised faceChannel under bandPolish-free mark
Bundle to bundleFlat stripSeparation
Cut endShort protectorSharp edge
Long spanSupport, not boardBowing
Reopened at siteSimple channelSurvives handling

Bands, interleaving and bundle support

A band directly on an anodised face leaves a line that cannot be polished out. A protector under the band spreads it, and a clean kraft face avoids transferring board marks.

Between bundles, a flat strip does the separating. Between profiles within a bundle, protection is usually interleaving rather than edge board.

Cut ends and the customer interface

Cut ends are sharp and are what the customer sees first, so a short protector at each end is often worth more than protection along the middle.

Where profiles are cut to length at the destination, the protection has to survive being reopened, which favors a simple channel over anything taped or wrapped.

A simple check when the bundle is opened: look at the anodised face under the band. A uniform light line means the load was spread; a sharp bright line means the band was on bare metal for at least part of the journey.

Questions buyers ask before ordering

Do extrusions break in transit?
Rarely. They bow or take surface marks, which is a different problem.

Why protect an anodised face?
Because a band mark on anodised aluminium cannot be polished out.

Does a protector stop bowing?
No. Bow comes from support spacing; the fix is packing, not board.

What about cut ends?
They are sharp and visible, so short protectors at the ends earn their place.

Full length or short pieces?
Short pieces at bands and ends, unless the pack also needs to be held square.

Send the panel edge, the band positions and the pack weight to mona@hengnicepacking.com and we will quote the profile that fits.

Inquire Now

If you have any questions or needs about the product, please fill in the following form and we will contact you as soon as possible.

+8615653268176