pulp production process

pulp production process

September 18, 2023

Pulp is one of the key raw materials for manufacturing paper and paper products, and is usually made from cellulosic materials such as wood, waste paper, and bamboo. The following is the general pulp production process, including the main steps:


1. Raw material collection:

    - Pulp preparation is usually based on wood, including pine, birch, eucalyptus, etc. Other sources of cellulose such as waste paper, bamboo or bagasse can also be used as raw materials. The wood usually needs to be sawn and debarked, then cut into small pieces.


2. Preprocessing:

    - Raw materials are pre-processed, including grinding, crushing and removing impurities, to prepare them for the next step in the process. This helps separate cellulose and improves production efficiency.


3. Pulping:

    - Pulping is the process of separating cellulose from raw materials. There are two main methods of pulping:

      - Chemical pulping: In chemical pulping, wood is soaked in chemicals (usually alkaline chemicals such as sodium hydroxide and calcium hydroxide) to break down the structure of the wood and separate the cellulose.

      - Mechanical pulping: In mechanical pulping, the cellulose is separated from the wood through mechanical methods such as cutting, grinding and tearing without the use of chemicals. This method works well with cellulose sources such as waste paper and bamboo.


4. Refining:

    - After pulping, refining is usually required to improve the quality of the cellulose and the dispersion of the fibers. This can be achieved with high-speed mixing or refining equipment.


5. Remove impurities:

    - The pulp may contain some impurities, such as residual wood chips, sand and other debris. These impurities need to be removed, usually through screening, washing and centrifugation processes.


6. Bleaching (optional):

    - If white paper needs to be produced, the pulp may need to go through a bleaching process to remove pigments and other impurities from the pulp. This can be achieved by using chemical bleach or oxidative bleaching methods.


7. Adjust pulp properties:

    - According to the requirements of the final product, additives such as oxalic acid and calcium carbonate can be added to adjust the properties of the pulp, such as pH value and brightness.


8. Storage and transportation:

    - Finally, the prepared pulp is usually stored in storage tanks and transported to the paper making machines via a conveyor system. It can be used to make various types of paper and paper products.


This is a general pulp production process, but the specific process flow and raw materials may vary depending on the type of pulp mill and product requirements. Throughout the process, quality control and environmental protection measures are very important to ensure the production of high-quality pulp and reduce adverse impacts on the environment.


+86 15653268176